After a extended period of down time I have started back into club work. So far so good except for my frequency analyzer lol I think it was enjoying it’s vacation. All the readings I am getting are off the charts 500 and up no matter the stated shaft flex. What am i doing wrong or what have I forgotten?
I would clamp it or bolt it down and try it just to eliminate that as a possibility. I doubt that is the problem, but before we take the next step why don’t you try it. If that doesn’t work, we will need to get it back and see if we can repair it. If we end up needing to get it back, call customer service, tell them you spoke to me and they will arrange to get it picked up and returned. Tell them to put a note on it to notify me when it is returned. How long have you had it?
I apologize for the issues. Rarely do we see problems with the Frequency machine, but with electronics it can sometimes happen. We’ll figure it out. I appreciate our patience.
Have not seen that as a problem. That being said, and I have to ask, if you are measuring shafts only are you putting the tip weight on? If you are measuring assembled clubs, gripped or ungripped, you should not be getting 500 cpm numbers. We would need to see the machine to figure out what the problem is. If you feel we need to take a look at it, contact customer service and they can make arrangements for a pick up. One thing you can try is to hold down the “AVG” button until you see “CLR” on the readout. This is suppose to clear all reading and allow for a new set of reading to start. You might just try clearing it to see if that works.
Let me know if you get it working or if you need to send it back.