Have not seen that as a problem. That being said, and I have to ask, if you are measuring shafts only are you putting the tip weight on? If you are measuring assembled clubs, gripped or ungripped, you should not be getting 500 cpm numbers. We would need to see the machine to figure out what the problem is. If you feel we need to take a look at it, contact customer service and they can make arrangements for a pick up. One thing you can try is to hold down the “AVG” button until you see “CLR” on the readout. This is suppose to clear all reading and allow for a new set of reading to start. You might just try clearing it to see if that works.
Let me know if you get it working or if you need to send it back.
Britt Lindsey
Hi Britt,
I have done both, measured Shafts with heads and with tip weight , ( no grips). I have also cleared the saved data many times. no luck.
I was getting quite a few b run”s before the the extra super duper maxi stiff readings.
I had one shaft that i got 3 consistent and accurate reading on. Then……..
The only thing I can think of maybe is I have not bolted it securely to the bench yet , Maybe the problem?
Thanks Reg