Installed a Callaway shaft adapter on a new shaft for Callaway Big Bertha 3 wood. After install, the screw on the head fits just fine. However, once turned as far as it will go is is a fraction short of seating properly. Therefore the head – while attached and not coming off – is lose. The screw will not tighten far enough.
How did I screw this up? More importantly, how do I fix this? By the way, there are two (2) washer on the screw in the 3 wood head. Just a guess but kit looks like one more washer would enable tightening. Just a guess though. I need advice from someone who actually knows what they are doing. : (