Question

1.05K viewsNovember 10, 2018

Rlafoone 1.57K November 9, 2018 0 Comments

Hi Group –

looking for the PTS of a Project X PXv Driver shaft used on Cobra Bio-Cell.

Shaft I believe was originally 44″ in length, but unable to determine if the PTS was 3″ of 4″.

I have several of these shafts that were tipped at some point, but without the correct PTS, I can’t determine how much.

Regards,

Randy

1 Answer

Answer 1 · 2018-11-13T20:04:42+00:00

It is likely the Project X PXv shaft that you have was made for Cobra and we would not have that shaft to take measurements from. We did stock a PXv Tour 52 shaft and still have a couple in stock and on this shaft I measured 28 5/8″ from the tip of the shaft to the base of the P in Project X.