My thoughts are to have the process redone and then re-shaft, re-grip, etc. Any thoughts?????
Jim,
Not sure I am understanding your question. If you have a set that has Pured shafts and you are removing them and putting them into another clubhead, you can mark the shafts before you remove them and then install into other heads. If you have shafts that have already been Pured but are not marked and are not installed, then unless they are gripped so you have a reference for orientation, you would have to have them Pured again. I apologize if I’m misunderstanding the question. If you can clarify I will try to give you better guidance.
Britt Lindsey
Britt …
Thanks for the post. There are no discernible markings from the Puring process and grips were gone. Gotta have them redone …. no choice! I appreciate your comments.
Jim D.