Question

1.63K viewsMay 18, 2020

brian 2 May 18, 2020 0 Comments

What is the bottom of the bore depth to the ground measurement on the TS 1 iron heads? Is the length the same for all the heads? So if re shafting with pulls, do you just add the BBDTG measurement to the existing shaft length? Thanks

2 Answers

Answer 1 · 2020-05-20T13:19:33+00:00

The 1″ is bottom of the bore to ground. That’s the measurement you need to calculate the length. To heel is a little more difficult to measure due to variations in the radius transition from the hosel to the sole as you move through the set. To the ground is what is important.

Britt Lindsey

Answer 2 · 2020-05-19T09:32:54+00:00

Bottom of the bore to heel measurement on the TS-1 irons is 1″. there can be very slight variances throughout a set, but they are very small. I checked an entire set and the variance was less than .020″ (20/1000) of an inch. If your installing pulled shafts, the playing length of the club in the playing position should be the length of the shafts plus the 1″.

Britt Lindsey

Hi Britt, would this measurement (Bottom of Bore to Heel) be different than Bottom of Bore to Ground Measurement?