Just wondering if there is any way to convert a spider x or similar mallet putter from a single bend shaft to either a plumbers neck or slant etc to create some toe hang?

It has a male stub that comes out of the head that the shaft slips over.

The stub is at 90 degrees if you look at it from the face, but it angles forward.

I was thinking of using one of the golfworks hosel adapters with a female to female adapter tube like the putter post adapter but I’m guessing that will angle too far forward due to the forward lean on the single bend post.

Could I do this and bend the hosel adapter to offset for the forward lean on the post?

Or is there another way that doesn’t involve cutting the stub off and boring a hole in the head?

Thanks!