I admittedly don’t get a lot of forward lean at impact so I was hitting the TS3 a little high and spinny. The landing angle and ability to stop were amazing but I know I was leaving a few yards out there....
I should have the pak to assemble later this week if it all works out. I’ll run down to the Trackman facility and get some numbers vs my Maxfli XC2 4i and 5i and post them.
There are a few topics on this. I believe Britt said it will make it close to a zero torque but the left hand necks are still on the way. It will be interesting to see what happens when someone tests it...
Have you considered a 9 wood? I have one on the way as we speak. I tried an old Cleveland model and it was so easy to hit it in the 185 range. I ordered the Maltby to play around with and if it works out,...
Shortening will always subtract. Bring a 50 series shaft it might be a little less than 3 full point, more like -2.5
The general rule of thumb is about 3 sw points per 1/2” but might be slightly different depending oh which shaft you have
I’m kicking around the idea of going with a set of XC2 irons just because I really like where the lofts are at and they look amazing. I see on the GG website that the Dart HDC shafts are the stock graphite...
Pjo336, I hit my TS3 dbm next to a chrome Maxfli XC2. They felt pretty much identical to me. I don’t think the dbm changes the feel at all.
For what it’s worth, we are in similar situations. I play a set of rocketballz irons I bought new in 2013 and played till about a year ago. I picked up a set of used Takomo 101t irons from eBay just...
Any plans on doing this with the MPF pro series + in the future? It would be nice to be able to order just a single.
I’m playing with swing weighting as well t right now. I ordered a TS3 without any swing weighting done and it came out to D8. I threw about 25g in the handle and got it do a D2 which I feel is a little...
Thanks for that. I always welcome real world experiences and other’s opinions. I am taking the TS3 7i test club to the course in about 30 minutes to put it through the paces. I tested it last night in...
Thanks Britt. So basically it really just depends on if I want the Gap wedge to match the TS3 or to match the DRT. It’s good to know that they will play basically the same, especially at my level. I...
Britt, Hope you had a great 4th weekend. I’m looking at ordering a set of TS3 irons in the very near future if all works out. I’ve pretty much decided on a 6-P with a 48, 54, 60 wedge setup along...
If you are referring to the black DBM finish, yes it will be there if you remove the paint fill. It is applied before paint and someone posted a picture of a set of DBM irons with the paint removed on...
Thanks for that info. I will see what the fitters say and go from there. Hopefully they will have a vista pro just to try something similar but it may not fit my swing at all. I would rather spend a little...
I put mainstream in quotations to imply brands that have a lot more advertisement and known to the general public. Something that most fitters would have in stock like a Fujikura, Mitsubishi, Aldila, and...
I am really interested in trying the MPF pro series + shafts but have never hit graphite irons before. I plan on going in to get a new fitting in the very near future and was wondering if there was a “mainstream”...
TM0023 is listed for the SLDR on page 148 of the catalog
I knew that they were based off the TC3 design and I had a chance to hit both recently. They do look and feel great. Last question as far as head size goes. Will the TC3.5 be a similar sole and top line...