Clubmaking Forum

discuss, ask and learn about golf and clubmaking

Hello, Britt stated that the m890 will be reintroduced as the m980 with a graphics change. He did not say when. I have a m890 set for sale. 5 hybrid, 6 through sand wedge, no gap wedge. UST Mamiya DHI...

View Question
0 Votes

sounds right, weigh your head and find a near matching weight hybrid loft, tip to that hybrid loft, GW can't recommend it, but I have done it successfully many times. I personally use an emory board and...

View Question
0 Votes edited answer

hello Jay, tip trim according to instructions, then butt trim. use the head weight as your guide to tipping. YouTube this: Guide to sanding .370 graphite shaft to .355 Taper by hand Golf Shafts...

View Question
0 Votes

Hello, I have a set of the previous generation Dart and the current mmt. They are nearly identical. Slight subtle feel in more dampness for the mmt. Likely due to the wire. I will assume that the stiffer...

View Question
0 Votes

reviews say 3.5 is more forgiving. there is a fb Maltby page you can join. Reviews the Dick's maxfli, similar to ts3 & ts3.5

View Question
0 Votes

being a lefty, you only have two options. ke4 max and the sti 2. google "maltby ke4 max vs. sti2 iron comparison". gives you the low down The Callaway Edge is listed in the MPF ratings at 808. Ke4 max...

View Question
0 Votes

here's a great video with data, but for steel shafts https://www.youtube.com/watch?v=jb0AIO3eFU4

View Question
0 Votes

Hello, in the how to section, Ralph Malby discusses trimming the shaft length based on the hybrid head weight. Whichever number iron is closest to your hybrid head weight, trim it to that iron specification.

View Question
0 Votes

witte, try a combination of their center shaft putter head (SKU:MA0336) and their most off set putter hosel (SKU:GW0138)

View Question
0 Votes

Reshaft one of your Pings locally, before diving into a new set of irons. Go have a shaft fitting, usually at no charge.

View Question
0 Votes
Load more answers