If I were to buy a set of .370 shafts, what would the chances the set were frequency matched in total?
Wouldn’t someone need to have a huge inventory or access to such to make sure the whole set came in numerically with a material difference or tolerance?
We do not custom build frequency matched sets. We can of course, but can not take the time to go through all you have to go through to do it. That being said, and like I have said before, it the parts are within tolerance and the progressions are what they should be in the head weights, trimming, club lengths etc., the set will be consistent as it should be in it’s frequency progression. We are very meticulous about building to proper lengths, swing weights etc. within the normal acceptable tolerances. When that is done, the frequency matching part usually takes care of itself. It does somewhat depend on the shaft and how it’s trimmed, is it parallel or taper tip…all things that can affect how the set would come out in the frequency numbers.
Britt Lindsey
Depends on how precise you want to be and what shafts you are using. In theory, if shafts are trimmed properly in the proper progression, the install is accurate with heads that progress by 7 grams throughout the set and have consistent bore depths, then you should get the proper flex progression in the set, if built to traditional length progressions. With todays tolerances of shafts, results overall are a little better than they use to be, maybe. Parallel vs taper tip sets, graphite vs steel, all can present different challenges. Building a precise frequency matched set can be a time consuming process, with adjustments generally needing to be made either in trimming or head weights, to dial in an exact progression. That being said, an exact progression is generally not something that is needed for a set to be consistent. If you can get a progression of 3 to 4 cycles between progressive length clubs in a set, that is good. I don’t think it is possible with any shaft to pull 8 shafts off the rack, build a set and expect there to be no “tweaking” needed in the build to get a precise frequency matched set. So to answer your question, you would most likely need a lot of shafts to sort to get a set of shafts that would require little or no adjustment to achieve a frequency matched set.
Britt Lindsey
Britt, to follow up on your answer, would GW build a frequency matched set within 3-4 cpm upon request? Would there be an extra charge? Thanks.
Thank You
OP, I’ve done about 7 CPM matched sets of clubs. All I can say is Jim Yachinich was right, if I charge a by the hour for a Frequency matched set they’d run you about $1500.00 just for that.
Don’t waste your time, watch 1 of the many Tour truck videos on YT. Tour Pros aren’t Flo’n, Frequency matching, Logo up for advertising and let them fly.