the below is a question that was asked a few months back…did I miss Britt’s response?

would be interesting to see how the markings on shafts compare to SST Pured..

thanks,

Randy

 

 

JayZee 6 months Ago

Hi Britt,

 

I was building an ISO-T driver with MPF shaft for a customer the other day and I started thinking about the alignment marks that are on the shafts at 12:00 and 9:00 (which are big time savers). What is the method that the factory is using to align the shafts for the markings (i’m assuming that they are aligning and marking before applying the graphics)? Have you guys compared the accuracy of these marks against the information that the PUREing machine provides (and if so, how do they compare)?

 

 Britt Lindsey answered 6 months ago

Comment

1 answer

Britt Lindsey 6 months Ago

The shafts are oscillation tested in a method similar to Pureing.  That being said, the accuracy is not as tight as the Pure Specs Alignment System we use.  I have not compared the marks on the Pure Specs machine, but I will and report back.  Should be interesting.

 

Britt Lindsey

Thanks for the reminder. You didn’t miss anything. I will check a shaft and report back as soon as I can.

Thanks again for the reminder.

Britt