Soooo, I’ve had some recent grips failing. I’m using 2 inch wide normal two sided tape, and mineral spirits as solvent. If I add a little pressure and twist I can move the entire grip, to the point that I can rotate the entire grip off the shaft. The tape stays in the grip and there is a goopy, sticky mess left on the shaft that I remove with acetone. Any thoughts? Usually, as always, when I pull a grip the tape is so attached the shaft it is a B to remove, but not here. When I pull the tape from the shaft it is kind of “wet” like I just added the solvent. I’ve never had this happen with mineral spirits, but can’t figure it out. All three have been GP cp2 grips.