Question

1.06K viewsSeptember 19, 2022

tfaudree 4 September 19, 2022 0 Comments

When I buy a set of PX Rifle parallel tip shafts that are labeled “3-PW” (all with different part numbers stamped on the butt end), am I buying 8 of the 41” blanks that have been tip trimmed for me, or were these manufactured in a different manner to be club specific? If I need a couple of extra of those Rifle shafts in the same flex for wedges, do I need to buy the 41” blank and tip/butt trim as instructed, or do I need to buy one that’s labeled as a wedge shaft like I would for a taper tip?

Britt Lindsey Answered question September 19, 2022

1 Answer

Answer 1 · 2022-09-19T13:55:45+00:00

If you buying .370″ parallel tip Project X Rifle shafts from us you can only get 41″ blanks. If you are buying a pre-packaged set marked as you indicate and they truly are .370″ parallel tip, they most likely are just trimmed from the tip prior to packaging. I was not aware anyone was still selling them that way. It’s been years, since we sold parallel tip discrete length Project X shafts. Even when we did, the factory would have just pre-trim 41″ blanks for the 3-PW designation. That is what they use to do. If yo need extra wedge shafts, all we could offer is the 41″ blank that you could trim. You would have to go to wherever you bought the set to see if they offer individual, .370″ parallel tip, pre-trimmed Wedge shafts.

Britt Lindsey