Question

Solved1.46K viewsNovember 7, 2022

Rlafoone 1.58K October 28, 2022 0 Comments

follow up from the previous question. from a short dialogue with Jim, I understand that if I set the KE4-TC to H, the loft will be 11* when the clubface is square to the target line. Face angle would be 0*

If the club would just be soled in it’s natural position, would face angle be 9* with a 2* closed face angle when in the H position.

Also, the chart says at H, loft is 11* (square to target line), face angle is open at 2*. I assume the 2* open means you would need to rotate the club 2* to make it square to the target line.

haven’t been out to the shop yet obviously :-)

thanks for your patience.

Question is closed for new answers.

Rlafoone Selected answer as best November 7, 2022

1 Answer

You are viewing 1 out of 1 answers, click here to view all answers.

Answer 1 · 2022-10-28T16:44:55+00:00

Pete and I just went and measured a head. In the H position on the head we measured, the lie is 60, the loft is 11 and the face angle is 0 or square and that IS with the head soled in it’s natural position. So, that is a little different than the chart we have, so Pete is going to re-check all the positions. In the N or Neutral position, the lie is 59, the face angle is 1 deg. open and the loft, when the clubhead is rotated to square, is 10 deg. The loft is 11 deg. at the 1 deg. open position.

So, not sure the discrepancy on what we measured from the original chart on the H setting, but we will re-check all the positions. Thanks for the question, as without it we may not have known of the slight variance. It could be that it is just on the head we measured and not on the production heads. We will find out.

Britt Lindsey