Anyone know what’s the right way to install the iron on this machine for bending? Any links to a manual?
Also the long hosel bending bar seem to be out of stock everywhere. Any alternative DIY ideas?
Thanks….
That is an older one. It is basically our Value Line Scale called the VAM. We use the instructions for another unit we call the GAM because the top part, the part you have, is basically the same. I have attached those instructions. Your third picture from the left is how the club should clamped.
https://www.golfworks.com/images/art/GAM.pdf
Hope this helps.
Britt Lindsey
There was an additional clamp on the GAM. I have looked for a manual for what you have and so far have not been able to find one. It was designed as a very basic way to secure an iron head for bending. It’s basically a simply clamp for irons. I’ll dig a little more to see if I can find anything.
Britt Lindsey
Thanks Britt. So the bending bit for loft and lie will be tricky as the club and shaft placement not upright like in the newer machines i have seen.. The GAM machine has an additional clamp for the club which is missing in this model that i have.
Any chance you may have a copy of the original manual for this ?