Question

857 viewsDecember 4, 2024

baggedlvintegra 37 December 4, 2024 0 Comments

I typically play an X100 8ir “spinner” setup in my 56/60 wedges but just bought the Max Milled PAKs and going to try to use the TT Score shafts. Currently gaming the TT Score in my TS4s 4-GW and I tip trimmed those to playing length tip only, which effectively was 3/4” more than the recommended “Stiff” profile from the tipping instructions (HS1.5 if you will). Final trim (tip only) on my GW was 6.25”.

My question is based on the above how much would I trim for the 56/60? The same 6.25” or something different to try to achieve the “spinner shaft” setup?

Britt Lindsey Answered question December 4, 2024

1 Answer

Answer 1 · 2024-12-04T12:55:29+00:00

You could trim them like you did for the 8 iron. That is assuming, if I understand you correctly, you trimmed the X100 for an 8 iron and installed into your 56/60 degree wedges. If you want them to be slightly softer, then that would be the formula I think. Or, you could trim them the same as the GW, the 6.25″, and the heavier head weights will also make them play slightly softer and probably be closer to the X100 8ir you are comparing too. I think the X100 8ir is probably stiffer than the Score LT trimmed the 3/4″ more, but that is just an educated guess. Would have to cut, compare, etc. to know for sure.

Britt Lindsey

Thank you, exactly the feedback I was looking for! Spot on as always I really appreciate it!