Hi, I reshafted 2018 Callaway rogue 3+, 4 and 7 woods with the Kurocage HBP shaft in regular. Attached are the specs that resulted. I used the W8 gap trimming for 3,5,7 woods, and started with the 3+ at no tip trim so they’d all play a little weaker, thinking I could tip them later if I found them too weak. Overall length as per original Rogue specs +1/2”. Oddly the frequencies are very close together. I should have weighed the heads, but I didn’t, hence the overall club weights are listed. I hit the 4 wood extremely well, the 7 good, and the 3+ some good and some not so good. My handicap is 8, and prior to some back issues and a resulting loss of swing speed I hit them all well with the stock stiff Evenflow blue shafts, so I don’t think the results with the 3+ are due to lack of ability. Would appreciate your comments overall and particularly the frequencies as well as suggestions for getting the 3+ and seven to play like the 4 wood. Thanks.
Hi Britt, the reason for the 1/4 tip trim was due to the fact that the 4W design length is only a 1/4″ less than the 3+. Given the tip trim code (W8)for the HBP shaft only lists 3W, 5W and 7W @1/2″, 3/4″, 1″ respectively, I interpolated the tip trim for the 4W. Regret not weighing the heads, and bore depth, I’ll do that if I have them off again. However, total club weight is only 2 grams between the 3+ and 4W, but 6grams between the 4W and 7W. The shafts and grip weights were identical for all three clubs. The CPM readings were with the grip on, but didn’t adjust the clamping pressure between measurements. It’s a Mitchell frequency machine. Yes, I will keep playing them and see how it works out. Thanks.