Question

1.19K viewsJune 18, 2019

Woody 227 June 18, 2019 0 Comments

I used the rubberized 10 gram weights on a set of TS-2 irons. And of course theyre way to heavy. I can remove the larger piece of weight stuck in the head by heating the head; the lead just drops out – but removing the remainder of the weight from inside the graphite shaft is really tough. It’s rubberized as we know and drilling isn’t very effective. I’m tempted to 1) leave the piece of weight in the shaft. or 2) try again with another Maltby shaft. Sheesh what a job. Any tips – and thanks in advance.

-Bill-

1 Answer

Answer 1 · 2019-06-18T14:40:18+00:00

We would drill it, using a self centering tool. If that did not get the job done, you could take a long thin rod and possibly drive the pieces out from the butt end. Or, using the thin rod, drive the pieces out from the tip end. It can be a bit of a pain, but you should be able to get it out. Leaving the piece of weight in the shaft is an option, if you can secure it so it won’t come loose.

Britt Lindsey