I ran across a stash of the above shafts. Aldila Velocitor 100. S flex. I’ve searched high and low for a trim chart for an S flex
Anyone heard of the shaft or the equivalent that I could use the trim numbers.
Many Thanks
– Bill
We don’t see a Velcitour 100, but found Velocitour CF combo, Velocitour Ultralite, Velocitour Plus. Are your shafts woods or irons? What we have for the CF woods state for an A or S flex trim 2″ from the tip for a driver and then 1/2″ increments through a #7 wood. For the R and L flex, it just says trim 1/2″ increments for the #3 wood through #7 wood. For Velcitour Ultralite woods and irons it states Butt trim to length to achieve flex. On the Velcitour Plus woods it states tip trim 1/2″ increments #3 through #7 woods. Do not trim more than 3″. For the Velcitour Irons it just says tip trim in 1/2″ increments for the #2 through the #9 irons.
That’s all we have. Nothing we can find in our Aldila archive that identifies a Velcitour 100.
Britt Lindsey
Thanks Britt. I was looking for irons, and this should keep me in the ballpark.
-Bill