Trimming as per the trimming specifications sheet , and all good until I reached PW and I was 1 1/2 “ short when trimming the shaft handle. That was very disappointing.
Britt Lindsey Answered question July 27, 2020
Trimming as per the trimming specifications sheet , and all good until I reached PW and I was 1 1/2 “ short when trimming the shaft handle. That was very disappointing.
Rlafoone is correct. Trim code is IR6, so you would trim 4″ from tip on the 41″ blank, leaving 37″ shaft to install. On a standard hosel iron you will gain at least 1″ from bottom of the bore to ground line (leaving you with 38″ club length before butt trimming. Standard length guideline for graphite shafted PW is 36″, so you should have had plenty of shaft to cut from the but to get to standard length.
Britt Lindsey
Interesting. Shaft is 41″ long, if you tip trim 4″ as specified, TRIM CODE IR6, the shaft is still 37″ long. Standard length for graphite PW is 36″!