Good afternoon,
What line on the trim chart is used for True Temper S300 wood shafts (.335)?
Thanks
Jim Yachinich Answered question November 12, 2021
Good afternoon,
What line on the trim chart is used for True Temper S300 wood shafts (.335)?
Thanks
Note that S300 only indicates that it’s a “stiff” shaft, not the model of the shaft. Not a lot of folks play steel in their woods these days.
The below is a response that Britt gave earlier this summer.
Britt Lindsey3.54K Posted June 16, 20212 Comments
I apologize for the delay in responding. What I have found is that on .335 tip steel woods, True Temper stated that the tip should be trimmed 1/2″ on bore thru woods, then in 1/2″ increments for each successive wood (#2 wood would 1″, #3 wood would be 1.5″ and so on). If it’s not a bore thru head, then you would trim nothing from the tip for the driver, and then in 1/2″ increments. That was on the Dynamic Gold .335 woods from 1990. Generally TT would have used the same trimming instructions on all the .335 tip steel wood shafts.