Curious if there was any profile change for tipping the TT Score beyond the IR11 spec would going a full inch extra cause any issues? Would this get closer to an XStiff?
Matt Answered question June 6, 2023
Curious if there was any profile change for tipping the TT Score beyond the IR11 spec would going a full inch extra cause any issues? Would this get closer to an XStiff?
Jim answered a couple similar questions to this on the TT Score product page. If memory serves, you should have enough parallel section to tip trim each club to length. This should obviously make it stiffer than IR11 with no issues. However, I’m pretty sure that would still get you no where close to X flex.
You’d have to trim these shafts at least 1.5” maybe more to get them to play X flex. Of course, doing that wouldn’t leave you with enough shaft to get them to a reasonably playable length.
That was one of my concerns as well. If only 1″ was trimmed I think it would be the entire tip trim to get to most lengths. ex (4iron =41″ shaft + 1″bore to ground -2.5″(IR11) – 1″ extra Tip = 38.5″ STD Length)
Would this play like a S+ instead of an X?