Have a set of these heads. Noted a few of the lies are up to 2 degrees flatter than spec. Can they be adjusted back to spec without breakage?
Have a set of these heads. Noted a few of the lies are up to 2 degrees flatter than spec. Can they be adjusted back to spec without breakage?
The BLACK PTM irons were not easy to bend and I would not recommend trying to bend them. 1 degree might be possible if you are very experienced in bending, but there would still be a risk. That particular head and material when treated with the Diamonized Black Metal finish did not like to be bent. Still a great design, IMO, but the DBM finish version of the PTM and it’s lack of adjustability was a negative.
Britt Lindsey
hi balto12 to below from Britt:
Britt Lindsey5.08K Posted May 29, 20200 Comments
On the PTM Black Forged irons 4 degrees would not be recommended. 1 degree is about the max. The PTM Satin Chrome head could possibly be bent 4 degrees. The DBM finish does affect the amount the PTM Black head can be bent. The original DBM iron head (MA0225) is the only DBM finish head that we can bend 2-3 degrees max. All other DBM finish irons and wedges tend to be 1 to possibly 2 degrees. It varies based on the material of the head.
Britt Lindsey
Britt, thanks for the response.