Clubmaking Forum

One other thing. You might hold off on the 60. I can’t play a 60 to save my life. I can play a 58 Max Milled fine. Two degrees doesn’t seem like much, but it’s huge to me for some reason.

My pitching wedge is 45, then I have a 50 gap, 54 sand, and 58 lob. My distance gapping between wedges is good. Those clubs are shorter so they swing slower. 4 degrees difference is standard, but in...

Usually a 4 degree gap between irons so you’d want a 52, referred to as a gap wedge.

https://www.clubguygolf.com The Club Guy.  He’s around Cary, NC.  He fitted and built my TS1s a few years ago.  Give him a call and see if he can help.  Great guy.

I was a 16-18 handicap playing shovels, Ping GMax (900+ MPF) and switched to TS1s years ago. The only thing I think I miss is a few yards when I hit off toe side badly.  I actually hit the TS1s (711 MPF)...

I have a TS2 6 iron with an A flex MPF shaft.  My 7 iron distance is the same as yours.  I like the MPF shaft in A flex, tried an R flex, but couldn't get along with it.  To me the R was more like an...

I was fitted into TS1s four or five years ago from Ping GMax irons with an MPF over 900.  The only thing I think I gave up was a tad of forgiveness on toe hits (smaller C-dimension).  Still a bad toe...

I used Golf Pad without tags and later with tags for years.  I reached a point where I didn’t want to fiddle like you and went to tagging clubs. Even tagging became a distraction. A couple years ago...

https://www.golfworks.com/finding-the-right-golf-shaft/

Thank you Britt!

I’ve tried looking!

Can someone post the link to Golfworks’ shaft spreadsheet that has weight, MPF, and  bout, mid, tip?  Mine is two years old.

I’m an MPF believer.  Read most of Maltby’s books and decided to go to a big name retailer and hit used clubs to test for myself.  That was years ago and I walked out with a used set of Ping Gmax....

2015 Cobra Fly Z XL MPF: 699 TS3: 849 TS4: 755 TS1 IM: 728 https://www.golfworks.com/head-mpf-ratings/

Ajg72 - I was playing Ping GMax irons (900+ MPF) and went to a local NC club fitter who built Maltby clubs.  I play TS1s (711 MPF) now.  He had a TS1 built up and let me hit it.  I actually believe...

I’m interested as well in what Britt says to your question.  Looking at the MPF (849 and 838) and the metrics that make up MPF, both are essentially the same for forgiveness all around.  To me that...

This might help: For comparing forgiveness- This details the MPF: https://www.golfworks.com/about-mpf/ MPF for club heads: https://www.golfworks.com/head-mpf-ratings/

I went through the same things a few years back.  I was a 16-18 at the time and wanted the TS1s.  I was playing Ping GMax irons - MPF over 900.  The TS1s are just over 700. A local club builder fit...

Golfworks will assemble.  Note specs or alterations (lie, loft, length, up/down of graphics for shaft/grips, SW, etc.) and you’ll be pleased.

Thank you Britt. I’ll check out the C6 and Steelfiber.