Thanks Britt. Understood
The Canadian website now has the KE4 Max on the site. Other than that there is such a hole in new models, including any FST shafts. It’s a disadvantage ordering from the US, but it’s quickly becoming...
Thanks Britt. I checked again today and they were not listed.
Not beating the drum again, but I do notice the MMB and the TE heads are dwindling down. Just wondering if we could expect the TS3 model on the Cnd site before mid winter. Thanks - Bill
Interesting. I ordered a couple of bottles of tour set epoxy. gel time 10-13 minutes. Maltby isn’t kidding. I prepped enough for an 8 club assembly. I got to about 3 clubs.. that’s when I knew....
I had a substantial order this week. Made it at 8 pm. Requested standard shipping. The next morning at 11am I had a notification that it was shipped! Terrific service, and this was from the Canadian store....
Thanks. The guys oblivious to what it could be. I’m thinking this is a home made vibration dampener. Sure is strange though. I think I can get a decent amount removed. Here really likes the FST. I feel...
This is a strange one. A customer wants a set of Maltby irons, on their set of FSTs. Upon removing the older heads, and drilling out the old epoxy in the shaft, I noticed that I could not fit a ram rod...
Thanks gentlemen. I was able to find the brass ones.
Whoa! That’s awesome. Best news this week.
I’m looking for simple lead tip weights. I understand the website difficulties, and staffing difficulties for Canadians. The website shows a picture of the weights. Upon clicking I get an error message....
Thanks to Golfworks and others I’m doing all repairs and builds for my local club! I have a player who wanted a lighter build. I started him with a Nippon 950 regular steel, and the TS2 model. Initially...
Due to Canadian shortages I can’t get the 4 ounce bottles of epoxy, but I can get the cartridges. I tend to warm the epoxy slightly for better flow. Are there any pitfalls I should be aware of, or is...
I still get comments on my trusty TE FORGED. Timeless design, thin top line, solid. I’m a fan of the older models. In fact for laughs I set up some old Tricept F2’s with some Nippon shafts. Solid as...
Sorry Brit. I’m not beating a dead horse here. But there are no 3 or 5 wood heads on the website, other than the utility woods . I did confirm by calling Canada golfworks. I just wanted to confirm that...
I’ve inherited a pail of shafts. The graphites are easily identifiable, but the steel have no shaft labels at all. I don’t have a shaft measuring device. Is there a easy way, (by sight) to tell if...
Thanks. I watched this as well. Unfortunately no plug was used. I think I’ll use a bit of heat, and dremel out some of the epoxy slowly. After the shaft change I’ll use a proper plug at the end of...
Thanks Riafoone and Britt. Certainly I’m concerned about the paint. I’ve learned that the bore thru shaft length is to the bottom of the club. I’ll be using a heat gun for sure, and cycling it on...
I have to replace a shaft on a bore thru Titleist driver head. The shaft has been replace once, and the customer wants his original shaft replaced. It’s appears that the older shaft was installed all...
The Canadian website appears to be getting a bit better. It’s showing correct amounts of supply materials and the supplies section is working correctly. The shafts section appears to be working correctly....