Commented on a post

Epoxy set up well, hard as a rock. When mixing the 2 parts together it turned cloudy and slightly whitish. Going to give it a try. Using on TM R1 shaft adapter. If it fails will post. Any advice on the...

August 16, 2022 2
Commented on a post

Epoxy is at least 3yrs old. First time the black turned clear. Used it a couple of months ago was fine, good results. Did the test 4/5 hrs. ago seems to be setting up compared to non mixed epoxy parts....

August 15, 2022 2
Asked a question
I'm using Golfworks high impact shafting epoxy 1:1 mix item no. EPX1 with dual plunger.

The black part of the epoxy is coming out clear also. Is this epoxy still ok to use? Is the black just a dye used for a visual aide for mixing?

August 15, 2022 2
Commented on a post

Took the tape off the shaft and it had some sort of manufacturing number. the last thing printed on it was -38 USA . I believe you are correct on the length. Thanks Britt.

July 19, 2021 2
Commented on a post

The shaft I'm replacing is a true temper dynalite gold XP R300 TAPER TIP. I forgot to mention the xp in title.

July 19, 2021 2
Asked a question
Replacing True Temper Dynalite Gold r300 taper tip golf shaft

I need to know what length shaft to buy. I'm replacing a Titleist AP1 712  7iron shaft. The broken club shaft Length is 36". The seller does not list new available shafts by number only by length. Any...

July 19, 2021 2
Commented on a post

Thanks. I was reading chart wrong. I thought every code below the IR30 was a tip trim to length not the specific code for IR30 and it was blowing my mind.

March 12, 2021 2
Asked a question
Tip trim to length only

What does tip trim to length only mean? I understand cut tip then butt trim to length. Example IR33 IRON TRIMMING CODE. It cant mean trim butt those inches and then cut tip to length, can it?

March 11, 2021 2
Registered
March 11, 2021 10