Thank you Britt!

Aloha golfers! Just wondering if the center weight of the Apex MB 2021 irons can be replaced. If so, where can one purchase them? Mahalo! Shakil

Thank you Britt and thank you Rlafoone!

Aloha fellow golfers! Trying to help a playing partner find a replacement for his Apex mb 8-iron. Elevate vss ETS 115 taper tip 8-iron Golfworks site shows out to stock. Any suggestions or if anyone...

Thank you Britt. It is for personal use. Held up ok on the weekend.

Today when I was reshafting a Hybrid using the Quick Set Epoxy VB1024. I got a phone call right after I had mixed the two parts. By the time I got back, it seemed to have gelled a little. The consistency...

Britt: As always! Thank you for your diligence and sincerity in responding to my post/question. I understand. Mahalo!

I have a question that got me this morning. I use the bending machine at our club to check lies on clubs before/after using them when ordered new. Recently I received a new set of wedges and measured the...

I failed. It is possible that the weight port was in there so tight that it embedded into the metal. I tried all the ways and even took it to a machine shop this morning. They tried their best best but...

Thank you statechamp. I will give it a shot. Have not tried the left hand drill bits. I will get them today.

Thank you Sloppytypist and Ralafoone. I used the butane torch. It took about 60 seconds for most expect couple of the irons took about 120 seconds. The 7-iron unfortunately was in too tightly and I...

I received my Gen 4 irons with SW of C9. I would like to change to D1 at least. I understand the weight port screw can be removed but it in there with red loctite. I tried briefly to remove it by applying...

Mahalo Britt

May I please ask what partnumber to use for the P7TW irons? It looks to be the longer ferrule. 1" perhaps?

thank you Britt!!!

Would anyone know what PING universal ferrules OD diameter to buy for iBlades and Blueprint? Are they the same ? I am not good at polishing after install and would like to minimize that. Thank you...

Thank you very much !!!

I would like to change my wedge shaft from s300 to s200 o my 50* gap wedge but only have a 5-iron S200 taper tip shaft. my question is can I tip it to the right tipping like a parallel tip shaft or is...

Britt, Looking for the actual weight that slides in the track. Found M1 driver 2017 weights online but not 2017 M1. There are for the older model M1 which are square in shape but need the triangular...

I was looking for the 2017 ( green line & single weight ) M1 fairway wood weight. I have not been able to find any online. I am looking for a total weight of ~19g. Right now including the track (5g)...