Clubmaking Forum

discuss, ask and learn about golf and clubmaking

Asked a question
GW 1040 Loft Lie Gauge - Help I am a novice...

Just purchased the GW 1040 Loft Lie gauge...First time using this type of machine..a relative novice...are there any additional instructions or video that could help me to better understand how to use...

September 25, 2020 2
Commented on a post

Britt, thank you and a lesson learned and really appreciate your great customer service. Btw just ordered the club gauge gw1040 from Golfworks... Thanks!

September 22, 2020 2
Commented on a post

Ok one more post! Golfworks is amazing!!! Called the customer service line...Pat picked up the phone! She was about to call me...Mr Lindsey had seen my post and already started addressing...so it is...

September 22, 2020 2
Commented on a post

A further on to my last 2 posts. In the daylight...all but one club show hairline cracks at the hosel. Only bent less than 1 degree based in the specs. Is this due to DBM? This is not good just made a...

September 22, 2020 2
Commented on a post

Follow on to my original post...Looked closer at the other clubs. The 7 and 8 iron have cracks too..and i only needed to bend 1 degree based on the specs in The catalog! I will be contacting Golfworks...

September 22, 2020 2
Asked a question
Loft bending cracks PTM Forged DBM

I just finished assembling a set of PTM forged DBM finish irons. On the pitching wedge and gap wedge I see minor cracks at the hosel. I needed to bend these two clubs at a 63.25 degree lie. Based on the...

September 22, 2020 2