I have Aldila shafts NV-3 60g 3.5 torque 370 parallel tip made for Cobra, anyone know what would the tip trimming be?
Britt Lindsey Answered question December 18, 2020
I have Aldila shafts NV-3 60g 3.5 torque 370 parallel tip made for Cobra, anyone know what would the tip trimming be?
I checked with Aldila and they show nothing they have that has “NV-3″ that they built for Cobra. Their advise was to trim 1/2″ increments from the tip from the 3-PW. Since you have the 4, you would start with 1″ for the 4, 1.5″ for the 5, etc. Personally, I would start with the 1/2″ for the #4, 1″ for the #5, etc. That is the trim instructions for the NV iron that we sell that is a 40” .370 parallel tip shaft. sounds like yours is more similar to that and it is safer to start the trim with the 1/2 inch on the #4 since we do not know exactly what the parallel tip section length is. After tip trimming, install in the heads and after the epoxy cures you can cut to your final playing length from the butt end of the shaft.
Britt Lindsey
Looks like you got farther than I did they wouldn’t even reply to my inquiry
I like your idea with starting 1/2″ for the #4
thanks for the help
They are usually really good about responding. I know some guys personally there, and we buy a lot of stuff from them, so … That shouldn’t matter. They should have responded to you. Anytime you need tech info and can’t get it from the manufacturer, let us know. We usually can.
Britt Lindsey
Shafts are for irons 370 4-PW