If it’s the RBZ Stage 2 Driver it is our BB9055 adaptor. We believe the same adaptor will work for the fairway. Obviously if you are removing an old adaptor you must use proper procedures and precautions to prevent damaging the shaft. If you are installing on new shafts, normal prepping of the tip procedures should be used. Lightly sand the tip to remove any paint or finish, and clean the inside of the adaptor with Acetone. One the inside of the adaptor is dry, you can use a high strength epoxy to install. If it matters where the graphics are, you want to install the adapator so that when it is installed to your setting, the graphics are in the right position. On the Hybrid, if it is the RBZ Stage 2 tour Rescue, the adaptor would be the TM0030.