Callaway X14 Steelheads 980 MPF vs. anything by Britt’s team +701 MPF , and the winner is always GWs. Note: the X14 is what I compare all clubs to , and it is my favorite nostalgic club over all...
iamlowsound appreciate the RoT!
Thank - you QuickFeet!
Britt, When fitting a player, what is the minimum / maximum ball height we would like to see? Trackman publishes some LPGA and PGA averages: LPGA 23-25 yards in height and PGA is 29-32 yards in height. ...
Wow, TS3 is only 110 behind KE4 MAX! BRAND MODEL YEAR MPF MALTBY TS3 Forged #6 2023 849
appreciate the advice
Britt, Looking at experimenting with weight under or behind the hands. Last year I played around with my putter, and ended up adding back weight + head weight in a combo that works. Zero science: ...
Britt, Specifically, for KE4 Tour TC Hybrids. Assume GW's recommended standard length. What is the anticipated distance change when you lengthen or shorten the shaft a 1/2 inch? Adding or subtracting...
I play Score LT stiff in my irons, would like something softer in my Hybrid. thank you in advance
Does the reason change if they are blended into the iron set at standard iron length (club head weight adjusted) , Vice the standard hybrid / recommended length?
Britt, Appreciate your time/comments. I know I have high spin and that probably pulls back the yards however I can stop the ball on my number (sometimes on the green too!). Learning about clubs and building...
please ignore the height apex, it is a SC300 issue when hitting into nets. when i put the other numbers into flightscope trajectory optimizer, heights are plus/minus 100 feet. Spin is on the high side,...
Any recommendations for Maltby club head / shafts combo? I play to a 9, and my predominate shot is left to right. My miss is left. I like to feel the shaft load and dislike shafts that don't have...
Britt, That time of the year when I start thinking about a building a new set of irons. I am leaning towards the following: KE4 Tour FDI H3/21 and H4/23 , and the KE4MAX 6/26 - Gap. I play to a 9,...
Britt, If you play your irons -1/2 from GW's standard length, what is the recommendation for the wedges. If the PW and GW would be 35 (-1/2 from 35.5) , how do you address the SW and LW? -1/2 from...
Could I get the opinions on this blueprint technique? Also, where exactly do you set the dowel above the hosel in the shaft?