Building set of TS3 irons and tip trimming LT Score for regular flex using the IR6 code. Do I trim all my wedges – PW, GW, 52, 56, and 60 at 4 inches? The PW and GW are TS3, and the 52,56, and 60 are DRT.
Michael-CCLGolf Answered question
Building set of TS3 irons and tip trimming LT Score for regular flex using the IR6 code. Do I trim all my wedges – PW, GW, 52, 56, and 60 at 4 inches? The PW and GW are TS3, and the 52,56, and 60 are DRT.
Yes. Once you get to what the trim code says for the wedge, that applies to all wedges.
The BBTG – bottom of bore to ground measurement can be different as you discovered, but it shouldn’t affect the flex or performance of the shaft, only the overall length of the club because the tip trim is the same for each club you built. Only the length is different.
I built the 5 wedges (TS 3 PW, GW and DRT 52,56, 60) with the 4 ” tip trim. Finished build and noticed that the ground to first step is 3/4 inch longer on the DRTs because of the longer hosel. Is this going to effect the flex, making them a 1/2 flex softer?