Upon pulling thePrecision Rifle 6.0 shaft I noticed the tip is .370. I plan to go with DG R300.
Shouldn’t it be .355?
Did Titleist make this upgrade with a .370?
Just need to to know which shaft I need. .355 Taper or .370 parallel.
Thank you
Titleist has been using .355″ taper tips and has pretty much always used them in their irons. The shaft would only measure .355″ at the very tip. It would measure approximately .370″ where the shaft exits the top of the hosel. It would help to know which model Titleist irons you have? Unless these have been rebored or were a custom order it would be odd for them to use a .370″ parallel tip.
Thank you.
I figure they have been rebored.
I was able to clean out the hosels with 3/8 bit.
With little resistance.