We are going to turn the web page for the new TC Pro driver on today. It should show up this afternoon. Actually the drivers have arrived and we should have them ready to ship the first of next week.
The Pro Series A flex actually tests stiffer than the Dart 75 R flex. It is a little stiffer overall but especially stiffer at the tip. The Pro Series R flex tests at least a full flex stiffer than...
I do not know for sure but if this is for a TSR3 driver it is likely they do not tip trim the shaft. They would just butt cut for their finished length. I do not have a bottom of bore to ground line...
Our Tape Stripper works very well on steel shafts. There is no problem using it on steel. I am always very cautious using it on graphite shafts. Especially graphite shafts with larger butt diameters. ...
Yes we will have the Nippon 850GH Neo iron shafts. We just added them to the web site this morning at this link. https://www.golfworks.com/nippon-ns-pro-850gh-neo-355-iron-shafts/p/np0029s/ They...
No the hybrid shaft will not fit a driver. The hybrid shafts have a .370" tip diameter and the driver shafts have a .335" tip diameter. They will not fit.
The Mizuno MP Type 2 driver is listed as a mid launch and low spin design. Club loft is the first factor that influences trajectory. Without knowing what you want the final trajectory to look like...
Yes all three set of these Hogan irons use .355" taper tip shafts.
The other thing that comes to mind is matching grip core size to shaft butt diameter. The CP2's are a .600" core size and if installed onto a smaller butt diameter shaft say .580" there is a good chance...
I would look at the KBS Tour (FS0018) as a shaft that would have similar playing characteristics as the Hi-Rev 2.0. Also the $-Taper FS0050) could be another option.
It is not like you will be able to make these R flex shafts play to an A flex. You would have to at least install a 3 iron shaft into the 6 to get these shafts to play close to an A flex. Installing...
I can tell you that this is not a Dynamic Gold. The standard Dynamic Gold .370" parallel tip shaft has steps that measure 1.875" and the .355" taper tip steps measure 1.75". In all the shaft information...
No pictures yet. Britt is out of the office this week and can possibly give you an update next week.
The ProForce V2 HL graphite wood shaft certainly could work well in the M2 driver. The stock shaft in the M2 was listed as the Fujikura Pro XLR8 56. It is a mid 50 gram weight shaft and was designed...
The bottom of bore to ground line measures right at 1.5" on the G410 drivers.
No they really will not have much of any effect on the swingweights. It takes a 9 gram change of shaft weight to change a club by 1 swingweight. In most non constant weight shafts that start at the...
Probably finding one on Ebay is going to be the only place you may find one these days. It will likely be a previously installed shaft. It is not very likely that you will find a new one that had not...
If you are looking at the MXBG0033 golf bags we are currently showing they are due in the week of November 22nd.
If this is a Dynamic Gold S300 you would follow trim code W2 if you are installing the shaft into a bore through. If you are installing the shaft into a blind bore you would add 1/2" to what it says...