I am trying to put a new shaft on a King Cobra TI oversized driver.  The shaft tip diameter is .370 and fit’s perfectly into the hozel.  I bought a .370 ferrule, but it doesn’t fit on the shaft.  Way too tight. even tried oil to no avail. ?

any help is greatly appreciated

Thanks

MJ

mjones9mm Posted new comment June 27, 2022

Did you sand the paint off the shaft tip? this is required to get the epoxy to grab.
If you have, heat the ferrule up under hot water. Or…you can always run a .375 drill or reamer through the ferrule.

Thanks Everyone, I will try these out.